Need help?Do you have a question about the Creality CR-Laser Falcon and is the answer not in the manual?
General| Laser Power | 10W |
|---|---|
| Laser Type | Diode Laser |
| Engraving Speed | 10000 mm/min |
| Laser Wavelength | 455 nm |
| Input Voltage | 100-240V |
| Output Voltage | 24V DC |
| Supported File Formats | BMP, JPG, PNG, SVG |
| Supported Materials | Wood, Leather, Rubber, Bamboo |
| Operating System | Windows |
| Connectivity | USB |
| Software Compatibility | LightBurn |
| Safety Features | Emergency Stop |
| Cooling System | Air Cooling |
| Focus Adjustment | Fixed Focus Laser (with sliding focus block) |
Store in a well-ventilated, cool, dust-free place. Operate within 0-35°C, avoid wet/stormy conditions.
Use only the provided power cord. Avoid touching electronic parts when powered. Switch off when idle.
Clean regularly, avoid moving parts, use protective plate, wear goggles, ensure ventilation, supervise children.
Keep fire extinguishers nearby and do not leave the machine unattended during operation.
Users must comply with local laws and regulations and avoid illegal use of the product.
Instructions for attaching the left and right Y-axis assemblies using T-shaped nuts.
Securing the X-axis profiles and attaching tripods and the control box assembly.
Detailed steps for installing the 5W and 10W laser modules correctly.
How to pause, resume, and cancel engraving jobs during offline operation.
To Next Page