5
• Back Up Files
o Back up the TF card files to your computer.
o Clear the TF card and transfer the G-code files for the engraving based on the
power requirements.
• Insert the TF Card
o Insert the TF card into the device’s slot.
o Use the Frame function again to confirm the engraving material’s position.
• Start Engraving
o Activate the engraving by pressing the Start button.
o Wait for the engraving process to complete and enjoy the final result.
Security Statement
When a laser engraver operates, it emits a high-density laser beam that heats material
surfaces to vaporize them without burning. However, most materials are inherently
flammable and can ignite, which may pose a fire hazard to the device and surrounding areas.
Warning:
1. Do not place the device near flammable or explosive materials, volatile solvents, or
heat sources. Ensure the device is in a ventilated, cool, and dust-free environment.
2. Always use the adapter and power cord provided with the device.
3. Regularly clean the body and laser module with an anti-static brush or a dry cloth
when the device is powered off.
4. Connect the silicone tube to the laser module, even when not using air assist, to avoid
lens contamination.
5. The recommended operating temperature for the power adapter is 5°C-35°C. Avoid
humid environments and do not use the device in thunderstorms.
To Next Page
Loading...
