Creality Falcon2 Pro - Operating the Device; Frequently Asked Questions

36
Operating the Device:
1. Frame Preview: Press Frame to enter the preview mode from standby. The laser
module will emit a weak beam and move along the X/Y axis to frame the target area.
The indicator will turn solid blue.
2. Start Engraving: In preview mode, press the Pause/Play button to start engraving. The
laser module will emit a strong beam and begin engraving. The indicator will remain
solid blue.
3. Pause/Resume: Press Pause / Play to pause the device. The indicator will turn to green
gradient. Press Pause / Play again to resume engraving.
4. Stop Operation: Press and hold Pause / Play for 3 seconds to stop the operation. The
device will beep once and reset. After resetting, the device will beep twice and enter
standby mode, with the indicator in green gradient.
Notes:
1. If the computer doesn’t have a USB-A port, use the provided A-to-C adapter for
conversion.
2. The device reads the latest engraving files in the first-level directory of the TF card. It’s
recommended to delete older engraving files from this directory to avoid confusion.
Frequently Asked Questions
• Why does the carved work fail to achieve the expected effect compared to the
original image? (For example, the engraving effect is relatively light, and the lines
appear crooked.)
Answer: This issue could arise due to several factors, which are important to address for
achieving the desired engraving results. The first step is to ensure that you are using the
recommended parameters for engraving and cutting, which can be found on the official
website or provided in the TF card. These parameters will guide you in selecting the right
settings based on the material you are engraving.
At the same time, it is crucial to check the hardware of the device:
• A. Screw Tightness: Make sure that all screws on the machine are properly
tightened. Loose screws can cause the machine's components to shift slightly,
which may result in misalignment during engraving.