Need help?Do you have a question about the Creality Falcon2 and is the answer not in the manual?
General| Laser Power | 22W |
|---|---|
| Engraving Accuracy | 0.01mm |
| Engraving Speed | 25000mm/min |
| Laser Wavelength | 455nm |
| Supported File Formats | BMP, JPG, PNG, DXF |
| Connectivity | USB, WiFi |
| Input Voltage | AC 100-240V |
| Output Voltage | 24V |
| Supported Materials | Wood, Leather, Paper, Fabric |
| Operating System | Windows, macOS |
| Software | LightBurn, LaserGRBL |
Steps to update the motherboard firmware via TF card.
Steps to update the laser module firmware via TF card.
Essential safety rules for laser engraver operation.
Detailed safety rules for machine operation and supervision.
Operating the machine directly from a computer.
To Next Page
