Creality Falcon2 - Assembly Instructions; Install Raiser Stands

1. 安装四个脚架（含脚垫）：为了适配不同工作台面的大小，机器四角各有 3 处位置可供安装，安装脚架时注意对称。
1. Install four raiser stands (including pads): There are 3 positions for installation at each of the four corners of the
machine, to suit different size of workbenches. Pay attention to symmetry when installing the stands.
备注： 另外四个脚架（不含脚垫）可增加机器高度，如有需要可叠加安装。
Note: The other four raiser stands (without pads) can be used to raise the machine. You can stack them if
necessary.
组装说明 Assemble directions
08
LASERAPERTURE