3. 预览模式下，按下开始 / 暂停按键，机器进入雕刻模式，此时激光模组会发出强光，机器开始雕刻，蓝色指示灯常亮。
如果需要暂停雕刻，请按下开始 / 暂停按键，此时指示灯变成绿色呼吸灯效果，再次按下开始 / 暂停按键可以继续雕刻。
如果需要取消雕刻，请长按开始 / 暂停按键 3 秒，机器会发出“滴”一声，随后机器复位，复位完成机器发出“滴…滴”两声，进入待机
模式，指示灯变成绿色呼吸灯效果。
3. 雕刻完成后，机器会长“滴”三声，随后机器复位，复位完成机器发出“滴”一声，进入待机模式，指示灯变成绿色呼吸灯效果。
In the preview mode, press the Start/Pause button to enter the engraving mode, the laser module will emit a strong
beam, and the machine will start engraving. The indicator will be in solid blue. If you need to pause the engraving, please
press the Start/Pause button, and the indicator light will pulse green slowly. Press the Start/Pause button again to
continue engraving.
If you need to cancel the engraving, please press and hold the Start/Pause button for 3 seconds, the machine will sound
a beep, and the machine will reset. After the reset is completed, the machine will sound two beeps and enter the standby
mode. The indicator will pulse green slowly.
3. After the engraving is completed, the machine will sound three beeps and then reset. After the reset is completed, the
machine will sound a beep and enter the standby mode, and the indicator will pulse green slowly.
控制面板 Control Panel
1. 指示灯灭：机器处于断电状态，或上电异常。
2. 白灯常亮：机器处于初始化模式，初始化完成后自动进入待机模式。
3. 紫灯闪烁：机器处于固件升级模式，同时蜂鸣器发出急促的响声，等待升级完成后自动进入待机模式。
4. 红灯闪烁：机器处于异常模式，同时蜂鸣器发出急促的响声，清除异常后自动进入待机模式。
5. 绿色呼吸灯（明暗渐变的效果）：机器处于待机模式，可按下 Frame 进入预览模式。
6. 蓝灯常亮：机器处于预览模式或雕刻模式，此时激光模组处于出光状态，需格外注意安全。
7. 黄灯闪烁： TF 卡中的根目录中没有 gcode 文件，此时蜂鸣器会发出“滴…滴”两声。
1. The indicator is off: The machine is in a power-off state, or some abnormality occurs.
2. Solid white: The machine is in the initialization mode, and it will automatically enter the standby mode after the
initialization is completed.
3. Flashing purple: The machine is in the firmware upgrade mode, and the buzzer makes a rapid sound at the same time.
It will automatically enter the standby mode after the upgrade is completed.
指示灯状态说明 Indicator Explanations
14
To Next Page
Loading...
