激光模组 Laser Module
AIR：检测当前经过激光模组的气流大小。
红灯闪烁：无气流。雕刻或切割过程中烟尘可能会污染镜片，请检查气泵工作状态并确保接入硅胶管。
橙灯常亮：小气流。雕刻时建议开启小气流，如果开启大气流，可能会影响雕刻效果。
绿灯常亮：大气流。切割时可根据个人需求调节气流大小。
FIRE：检测加工材料是否正在燃烧。
红灯：检测到火焰，为确保安全建议立即停止当前工作。
橙灯：有火灾隐患，请确认材料并合理设置工作参数。
绿灯：未检测到火焰，请定期清理维护激光模组。
LENS：检测激光模组镜片是否脏污。
红灯：镜片严重脏污，请立即停止当前工作，并清理维护激光模组。
橙灯：镜片轻度脏污，建议尽快停止当前工作，并清理维护激光模组。
绿灯：未检测到镜片脏污，请定期清理维护激光模组。
AIR: Detects the current airflow passing through the laser module.
Flashing red: No airflow. Smoke and dust may contaminate the lens during engraving or cutting, please check the
working status of the air pump and ensure that the silicone tube is connected.
Solid orange: Small airflow volume. It is recommended to enable a small airflow volume when engraving, since a large
airflow volume can affect the engraving result.
Solid green: Large airflow volume. The airflow volume can be adjusted according to individual needs when cutting.
FIRE: Detects whether the processed material is burning.
Red: Flame is detected. It is recommended to stop the current work immediately to ensure safety.
Orange: There is a fire hazard. Please confirm the material and set the working parameters properly.
Green: No flame is detected. Please clean and maintain the laser module regularly.
LENS: Detects whether the lens of the laser module is dirty.
4. Flashing red: The machine is in abnormal mode, and the buzzer makes a rapid sound at the same time. It will
automatically enter standby mode after dealing with the abnormality.
5. Pulsing green (slowly): The machine is in standby mode, and you can press Frame button to enter preview mode.
6. Solid blue: The machine is in preview mode or engraving mode, and the laser module is emitting a beam. Special
attention should be paid to safety.
7. Flashing yellow: There is no gcode file in the root directory of the TF card, and the buzzer will sound two beeps.
15
To Next Page
Loading...
