4
Instructions
• Install the Software
o Download and install the engraving software (LightBurn).
o Use the camera’s calibration function before engraving to ensure precision.
o Follow the instructions in the file on the TF card: "Camera Calibration and
Alignment".
• Product Assembly
o Follow the assembly steps in the product manual.
o For further guidance, refer to the video on the TF card under "Assembly
Instructions".
• Adjust the Focus
o Place the engraving material on the machine.
o Use the multi-level fixed focus block to achieve the correct focus.
o Connect the computer and device to begin the engraving process.
• Make an Engraving Picture
o Select the picture or design to engrave.
o Higher-resolution images will result in clearer engravings.
• Set Parameters
o Set the engraving parameters by referring to the file on the TF card:
"Parameter Recommendation".
o You can also adjust parameters through the engraving software or consult the
"Software Operation Tutorial" on the TF card.
• G-Code for the First Creation
o Use the provided G-code file from the TF card to connect the device for the
first engraving.
o This G-code tests the structural stability of the machine.
o Use the Frame function to adjust the engraving position before starting.
To Next Page
Loading...
