07
6. Leveling Platform
Note: The platform has been leveled at the factory. If it needs leveling due to transportation or other reasons, please follow the steps below to
adjust the printing platform.
1. Raise the platform, loosen rubber screws on the left
and right sides of the resin vat, and take out the resin vat.
2. Loose the four screws on the connecting
plate on molding platform plate, attach
calibration card on the printing screen,
press Settings →Print Settings→ Z axis
movement →Leveling, Check whether the
platform fits evenly with the paper by
referring to the steps on Page 8.
3.After confirming that the calibration
card fit evenly, lock the four screws of the
platform.
To Next Page
Loading...
Need help?
General
