Creality Halot-Sky - Start Printing; Slicing Software and Model Preparation

9. Start Printing
12
1. Slicer
2. If the model needs to add support, click the upper left icon
to set corresponding parameters.
wait for slice to be finished→save the sliced file （Please refer
to the official website www.creality.com for more details of
slicing tutoria).
4
kcilC 3. Click icon ①→Setting slice printing parameters②→
①
②
①
②
no ”nepo“ kcilc ,retnirp D3 DCL fo erawtfos eht nepO .1
the left of the screen and add model file.
slicer
Note: The UI interface is for reference only, and shall be subject to the actual UI may be different.