Create SILKAIR CONNECT - Drainage Instructions; Manual Drainage; Continuous Drainage (Optional)

12
ENGLISH

the window sealing plate assembly.
Important Notice: The length of the exhaust hose shall be between 280 and 1,500mm, and

or replace it with other different hoses, or this may cause a malfunction. Exhaust host must
be not blocked; otherwise it may cause overheating.
MANUAL DRAINAGE
CONTINUOUS DRAINAGE (OPTIONAL, ONLY APPLICABLE TO DEHUMIDIFYING MODE)
• When the air conditioner stops after the water tank is full, turn off the machine power and
unplug the power plug.
Notes: Please move the appliance carefully, so as not to spill the water in the water tank at
the bottom of the body.
• Place the water container below the side water outlet behind the body.
• 
into the water container.
Notes: Keep the drainage cover and the water plug properly.
• During drainage, the body can be tilted slightly backwards.
• If the water tank cannot hold all the water, before it is full, stuff the water outlet with the

• When the water is discharged, stuff the water plug, and tighten the drainage cover.
• Unscrew the drainage cover, and unplug the
water plug.
• Set the drainage pipe into the water outlet.
• Connect the drainage pipe to the bucket.
DRAINAGE INSTRUCTIONS
*Drainage pipe not included in SILKAIR
CONNECT and CONNECT PRO.