12
WALL MOUNTING
1. Determine dryer position
on the wall and mark required
bracket position. This dryer
is not suitable to be directly
placed on top of a washing
machine.
NOTE: A minimum 50mm
is needed between the top
of the dryer and the ceiling
for ease of installation.
NOTE: If mounting above
a washing machine, allow
sufficient room to open the lid of
the washer.
Tools Required
* Tools and parts required for plaster or
wooden wall.
Drill & 3mm Bit 1
Philips Head
Screw Driver
1
Wood Screws
Ø12 x 50mm
4
Helper to lift
the dryer onto
the wall
1
Wall Mounting Kit Includes
Exhaust
Connector
1
2. Install the Exhaust Connector.
Adjust the direction to suit the
installation (see Figure Nine).
3. Rotate the Connector
clockwise to fix the pipe
to the Connector Base,
once connected tighten.
Figure Nine
Connector
Base
Exhaust
Connector
To Next Page
Loading...
