Creda C3TDW - MAINTENANCE; REMOVING THE FILTERS; CLEANING THE FILTER; RE-INSTALLING THE FILTER

17
MAINTENANCE
NOTE: The filter fixed in the
bottom of the drum should also
be cleaned with a soft brush.
NOTE: Please unplug the
power cord prior to any cleaning.
The lint filter must be in place
whenever drying. It must be
cleaned before each use.
REMOVING THE FILTERS
Remove by pulling outwards with
fingers, inserted into the four
holes around the exhaust vent
shroud. The filter is in 3 parts:
Exhaust vent shroud, lint filter
and exhaust filter.
Figure Fifteen
Figure Seventeen
Figure Sixteen
Exhaust
Vent
Shroud
Lint
Filter
Exhaust
Filter
Filter fixed in the bottom
of the drum
CLEANING THE FILTER
Separate “exhaust vent shroud”,
“lint filter” and “exhaust filter”.
Clean the lint on the lint filter and
exhaust filter with a soft brush or
vacuum cleaner.
Lint
Filter
Lint Exhaust
Filter
Dust
Cleaner
RE-INSTALLING
THE FILTER
After cleaning, assemble in the
sequence of “exhaust filter - lint
filter- exhaust vent shroud”, align
the recesses in the center with
the projection in the center of the
drum. Make sure that it is firmly
inserted.