29
English
DEPTH STOPWATCH (GAGE DIVE MODE)
During a dive in GAGE mode you can activate a resettable depth stopwatch.
To activate the depth stopwatch press and keep down the
ESC
button.
The last line will supply stopwatch data as shown in the figure below.
Press the UP button to start or stop the stopwatch, press the DOWN button
to reset the stopwatch.
Press
ESC
to go back to the average depth and temperature screen.
The last value seen from the stopwatch will be recorded in the logbook.
USING THE COMPUTER IN POOR VISIBILITY CONDITIONS
If at any time during a dive the lighting conditions make the display hard to read,
you can turn on the backlighting function by pressing the LIGHT button. The di-
splay backlight stays on for a few seconds and then goes out automatically. When
the backlight is ON you might notice some dark stains on the display: this is not a
defect, as the stains are due to the use of a high-contrast display.
SURFACE INTERVAL
After a dive in MODE-S AIR or MODE-S NITROX mode, when you ascend to
depths of less than 0.8m, the display supplies the following information:
• Surface interval in hours and minutes (SURF.T)
• Desaturation time (DESAT), i.e., waiting time before you can board a plane
(in hours and minutes).
IMPORTANT: The GOA/CARTESIO computer has been designed solely for
amateur sport use, and it is not intended for professional uses requiring prolon-
ged dive times and posing higher decompression sickness risks.
DANGER: Cressi categorically advises against diving with gas mi-
xes other than air without first having taken a specific course. The
so-called “technical” dives, in fact, may expose the scuba diver to
risks other than those associated with recreational dives, and which
may cause severe physical injuries or in extreme cases even death.
IMPORTANT: After a dive performed in GAGE mode, the instrument will not
make saturation/desaturation computations for 48 hours.
DANGER: If you decide to reset the instrument by accessing the sy-
stem mode, the nitrogen memory will be deleted and the instrument
will not be able to compute a subsequent dive as such. Do not use
this function until at least 48 hours have elapsed from your last dive.
When the GAGE mode is active, the GAGE icon appears.
NOTE: The GOA/CARTESIO computer is set in the factory to the MODE SET
(MODE-S) AIR mode.
NOTE: The depth sensor supplies indications between 0 and 120 m.
DEPTH
STOPWATCH
START / STOP
RESET
To Next Page
Loading...
