30
English
• Access the PC function of GOA/CARTESIO by pressing the
SEL
button from
the SYSTEM menu.
Then, following the instructions you can easily download all the data contained in
GOA/CARTESIO, such as the profiles of your dives, and can reproduce, print and
change the data through the software.
CARE AND MAINTENANCE
GOA/CARTESIO by Cressi has been designed and constructed to withstand in-
tensive underwater use. However, you should keep in mind that it is a precision
instrument and deserves to be handles with care. It is good practice to avoid
violent shocks, protect it from excessive heat sources, rinse it in fresh water after
use, dry it carefully, and never store it wet, avoid contact with heavy equipment
such as the dive tanks.
IMPORTANT: Do not let the computer come in contact with solvents or chemical
substances of any sort. Do not use compressed air to dry it. The button has no spe-
cial maintenance requirements: do not lubricate it with any oil or spray of any sort.
NOTE: When you change the battery, check the compartment: if you notice
any signs of moisture inside, send the instrument to an authorized service
centre. In the presence of any malfunctions, do not use the instrument to dive
and contact an authorized Cressi dealer to have it overhauled.
• NO FLY time and the relative icon. When this icon is ON, it tells you that you
should avoid plane flights and should not go to altitudes higher that the
altitude of the dive site.
• Maximum depth of the dive just ended.
• Dive time.
IMPORTANT: Pursuant to the indications provided by primary scuba diving
and hyperbaric medicine organizations, GOA /CARTESIO applies the no-y
times as follows: 12 hours after a single dive within the safety curve (without
decompression). 24 hours after a dive outside the safety curve (with decom-
pression) or repeated or multi-day dives performed correctly. 48 hours after
diving in GAGE mode or if severe errors have been made during the dive.
NOTE: If you start a new dive after a surface interval of less than 2 minutes,
GOA/CARTESIO interprets the new dive as the continuation of the previous
one: the dive number remains the same and the computation of dive time
resumes from where it stopped. Dives made after a surface interval of at
least 2 minutes, instead, are considered subsequent dives. If the previous dive
was made in GAGE mode, the instrument cannot make saturation/desaturation
computations for 48 hours after the end of the dive, denoted by the surface
interval SURF.T.
PC LINK - PC COMPATIBLE INTERFACE
GOA/CARTESIO by Cressi can be interfaced with a Personal Computer having
the following characteristics:
- Operating system: Windows/Mac
To connect the two computers, proceed as follows:
• Install the UCI Underwater Computer Interface software in the PC.
• Connect the Cressi interface hardware to an USB ports in the PC.
To Next Page
Loading...
