9
English
CHRONO (STOPWATCH)
From this screen, press
SEL
to access the functions
To turn the stopwatch On and Off press the UP button
To reset it (with the stopwatch off) press the DOWN button
The rst line of the display will read CHRO, the centre line shows the current time,
and the last line shows the stopwatch data.
During the rst 10 minutes, minutes, seconds and tenths of second are shown.
After 10 minutes, hours, minutes and seconds are displayed.
After 24 hours, the stopwatch is reset.
When you exit the function, the data is retained until the following
reset.
To exit the mode, press the
ESC
button.
MODE-S (MODE-SET)
The function lets you select the desired dive mode.
To access the function, press the
SEL
button.
The first line will read
SEL
and will show the mode currently selected (flashing).
By means of the UP /DOWN buttons, you can select the various modes
• AIR for dives with air
• EAN for dives with enriched air (Enhanced Air Nitrox).
• FREE for apnea dives
• GAGE for the depth gauge/depth stopwatch function
• OFF (padlock ) to turn off the pressure sensor (when swimming in a pool
or when you do not want the computer to log your dives).
Confirm the desired mode by pressing the
SEL
button until you hear the
confirmation beep.
Press the
ESC
button to go back to the main menu.
I NOTICE: When the dive computer is OFF it is essential to enable it before
each dive. For safety purposes, in fact, the computer will remain blocked du-
ring the dive and it can only be enabled by returning to the surface and raising
it off the water. Once enabled, the computer will not consider the time elapsed
until then. Accordingly, we recommend that you do not continue diving right
away and wait 24 hours for complete desaturation.
SEL ESC
To Next Page
Loading...
