225
NOTE: the first apnoea dive of the daily series is noted in
brackets with 1 (meaning dive 1), the second with 2 (dive 2),
and so on.
4 Maximum depth reached during the apnoea dive, given in
m or ft.
5 Dive’s number: the most recent dive’s information is given
first.
To view the second logbook display mode, just depress but-
ton D ( ). The mode’s number 1/3 is replaced by 2/3,
meaning the second of the three available logbook modes
related to the apnoea dive.
This mode supplies the following data (picture 47):
1 Apnoea dive’s starting time (the time at which the compu-
ter has gone below 4 ft., starting the (FAEE) computing pro-
gram);
2 Apnoea dive’s end time (the time at which the computer
has gone above 4 ft.)
3 Apnoea dive’s average depth (AVE) given in m or ft.
4 Apnoea dive’s total time, given in minutes, shown by the
"DIVE T." icon
To revert back to the first display mode, just depress button
C ( ), to view the third logbook display mode, just
depress button D ( ). The mode’s number 2/3 will be
replaced by 3/3, meaning the third and last available mode
related to the apnoea dive, which supplies the following data
(picture 48):
1 Water temperature at the maximum depth, given in °C or °F.
2 Surface interval since the previous apnoea dive given in
minutes (picture 3a) and seconds (picture 3b).
3 Total time of the apnoea dive given in minutes and
seconds, shown by the "DIVE T." icon
To view the display modes related to the previous apnoea
dives, depress button D ( ) again. By keeping the button
depressed, you enter a rapid sequence of the first display
modes related to the previous apnoea dives.
By depressing button C ( ), the display mode will
change, while by keeping it depressed, you will enter a rapid
sequence of the first display modes related to the subseu-
quent apnoea dives.
Related topics:
• 2.6. - FAEE (or Apnoea) program parameters setting.
• 2.7.2. - Date and time adjustment
• 2.7.3. - Units of measure setting
• 3.7. - FAEE (or Apnoea) program
• 4.1.3. - Surface interval after a FAEE program
4.3. – Dive historic memory (
HIST
).
4.3.1. –
DIVE
program dive historic memory.
Cressi-sub computer is also equipped with a historic
memory for DIVE program dives (HIST). To start this function,
depress button A ( ) in sequence until the (HIST) icon
appears on the display (picture 49). This program supplies
information related to:
1 total time of DIVE program dives, given in hours;
2 maximum depth reached during the dives (given in m or ft);
3 dives’ total number, shown by the “DIVE” icon
ENGLISH
To Next Page
Loading...
