228
Related topics:
• 4.2. - Dive logbook.
• 4.3. - Dive historic memory.
• 4.4. - Dive profile.
4.6. - Instrument reset
The instrument may be completely reset, by using the file
“ _RESET.exe” contained in the utilities of Cressi PC
Logbook software in the PC interface (accessory). By doing
so, the data related to the nitrogen absorption of a DIVE pro-
gram dive will be cancelled and the data stored in the other
programs will be reset.
WARNING: by resetting the instrument, all computation
related to current de-saturation are cancelled! Do not
reset your instrument if it has to be used to compute sub-
sequent dives!
NOTE: Dive logbook, profile and historic memory will be
stored in the memory even after the instrument has been
reset.
This function may be especially useful in the event the instru-
ment is rented by Diving Centres.
You need to comply with the following directions before star-
ting _RESET.exe program:
EDY RESET UTILITY
1. Application
This document applies to the utility to reset .
2. Function
This utility can be reset dive computer like as warm boot.
These setting and calculation data were cleared as follows:
1) Dive mode setting like as Dive, GAGE and Free mode
2) Surface time count and de-saturation time count
3) PGT and OLI value
4) Lock condition
And these setting were not cleared as follows:
1) Current time and calendar
2) Dive setting such as FO2, PO2Max, Depth alarm, Dive
time alarm (free) and USF
3) Unit setting
3. How to use it to dive computer
A.) Installation
- Please install PCLOGBOOK V6.0 before using this utility to
install USB driver for this
PC Interface unit.
- Copy utility to your storage on PC (It is not necessary to
specify folder)
B.) Run utility
Click icon (EDY_RESET.exe).
Below screen will be shown on screen if utility could find PC
Interface unit.
If it success to reset dive computer, below screen will be
shown and dive computer will
be into time set mode after exit PC mode.
To Next Page
Loading...
