Description: Clear All Dive Logs Clear
(LOG Clear)
To Access: From SETTINGS, press the
UP Button / DOWN Button until the cursor
aligns with LOG CLR. Press MODE Button
once.
One of the LOG CLR options will be
blinking at the bottom. Press UP Button /
DOWN Button to select other options as
needed. Press MODE Button to accept
your selection.
Options: ON / OFF
Note:
1. By Clearing all dive logs, all logs will
be deleted permanently. There is no
way to retrieve them.
2. Clear logs won’t affect any existing
settings and residual nitrogen
calculation of previous dives
existing on this dive computer will
still be calculated.
Description: System Reset
To Access: From SETTINGS, press the
UP Button / DOWN Button until the cursor
aligns with SYS RST. Press MODE Button
once.
One of the SYS RST options will be
blinking at the bottom. Press UP Button /
DOWN Button to select other options as
needed. Press MODE Button to accept
your selection.
Options: ON / OFF
Note:
1. By resetting system, all the custom
settings will be erased and all
settings will be reset as default.
2. Residual nitrogen calculations will
still be calculated and will NOT be
cleared and reset.
3. Dive logs will NOT be cleared and
reset.
To Next Page
Loading...
