Powering DM 8G+ Devices Using PoDM
NOTES:
l The POE IN port does not provide a network connection. The port is
only used to enable PoDM or PoDM+.
l The internal power supply of a DM switcher does not power DM 8G+
endpoints.
l When PoDM or PoDM+ is used to power a DM 8G+ endpoint,
connection of the endpoint to a power pack is not required.
l Cabling that connects to a PoDM or PoE PSE port is designed for
intrabuilding use only.
Route Inputs
Route inputs to one or more of the available outputs by using the front
panel controls or the web interface.
Route Inputs Using the Front Panel Controls
To route inputs using the front panel controls:
1. Press the ROUTE button. The AUDIO, VIDEO, and USB LEDs light,
indicating the signal types that are to be routed. (Pressing the AUDIO,
VIDEO, and USB buttons selects or deselects the corresponding signal
type.)
2. Press the appropriate IN button that corresponds to the input to be
routed. The LED of the selected input lights. In addition, the LEDs of
the outputs to which the input is currently routed also light.
3. Press the appropriate OUT buttons that correspond to the desired
outputs. The LEDs of the selected outputs flash to indicate that the
input is not yet routed.
4. Press the ENTER button to route the input. The LEDs of the selected
outputs light steadily. The display shows the input number and the
outputs to which the input is routed.
To disconnect an input from an output:
1. Press the ROUTE button.
2. Press the desired OUT button. The display shows IN None.
3. Press the ENTER button. The output is disconnected from the input.
5
DM-MD8X8/16X16/32X32-CPU3(-RPS)
QuickStart
DigitalMedia™ Switchers
To Next Page
Loading...
Need help?
General