Product Manual — Doc. 9239A GLS-OIR-CSM-EX-BATT • 21
2. Place the device into Acquire mode by doing the following:
a. Tap the TEST button three times, then press and hold it down (tap-tap-tap-
press+hold) until the green LED on the device flashes once (this can take up to 10
seconds)
b. Release the button to start the acquire process. The green LED flashes slowly to
show that the device is actively scanning the infiNET EX network.
i. The device is acquired when the green LED lights for 5 seconds.
ii. The red LED flashes 10 times to indicate that the device was not successfully
acquired to the infiNET EX network. Ensure the gateway is in Acquire mode
and within range before attempting the acquire process again.
3. Take the infiNET EX gateway out of Acquire mode from the unit itself or from Crestron
Toolbox, as described in the latest version of its manual.
Leaving an infiNET EX Network
To leave an infiNET EX network, put the device into Acquire mode when no gateway is in Acquire
mode.
Verifying Communications Status
To check the communication status of the device, tap the TEST button three times, then press
and hold it down (tap-tap-tap-press+hold) for less than 2 seconds. The green LED indicates the
communications status. Refer to the following table for details.
LED Communications Status
Turns on for 5 seconds The device is communicating with the control system.
Flashes three times The device is not communicating with the gateway, but the
gateway is not communicating with the control system.
Flashes twice The device was previously joined to the network but is not
communicating with the gateway.
Flashes once The device is not joined to the network.
To Next Page
Loading...
