20 • GLS-OIR-CSM-EX-BATT Product Manual — Doc. 9239A
Replace the Battery
To replace the battery:
CAUTION: The battery used in this device may present a risk of fire or chemical burn if
mistreated. Do not recharge, disassemble, heat above 212°F (100°C), or incinerate. Replace
the battery with an Ultralife 9V lithium battery only. Use of another battery may present a
risk of fire or explosion.
1. Rotate the cover of the sensor counterclockwise to remove the cover.
2. Remove the battery from the sensor.
3. Disconnect the battery from the two terminals in the sensor.
4. Connect the new battery to the two terminals in the sensor and secure the battery into
the housing.
5. Rotate the cover of the sensor clockwise onto the installed base until it is secured in place.
The assembly clicks when secured.
NOTE: Dispose of a used battery promptly. Keep away from children. Do not disassemble
and do not dispose of in fire.
Wireless Communications
The device connects to the Crestron network via the infiNET EX communications protocol. Use
the procedures outlined below to join or leave an infiNET EX network and to verify
communications between the device and the control system.
Joining an infiNET EX Network
Before a device can be used in a lighting system, it must first join an infiNET EX network by being
acquired by an infiNET EX gateway:
NOTE: A device can be acquired by only one gateway.
1. Put the infiNET EX gateway into Acquire mode from the unit itself or from Crestron
Toolbox, as described in the gateway’s manual at www.crestron.com/manuals.
NOTE: In an environment where multiple gateways are installed, only one gateway
should be in Acquire mode at any time.
To Next Page
Loading...
