22 • GLS-OIR-CSM-EX-BATT Product Manual — Doc. 9239A
Firmware Upgrade
NOTE: Before using the GLS-OIR-CSM-EX-BATT, ensure the device is using the latest
firmware. Check for the latest firmware for the GLS-OIR-CSM-EX-BATT at
www.crestron.com/firmware. Load the firmware onto the device using Crestron Toolbox™
software.
To upgrade the firmware on the GLS-OIR-CSM-EX-BATT, follow the procedure below using
Crestron Toolbox (v. 2.36.216 or later):
1. Select Tools > Network Device Tree View.
2. Right-click the gateway in the Network Device Tree View window.
3. Select Functions > Firmware Upload (Deep Sleep).
4. Select the Load Firmware File button in the Firmware Upload (Deep Sleep) window and
browse for the firmware in the Open window.
5. Once the firmware is selected, select Open to add the firmware to Firmware Images.
6. In the Assignments section, select the device (CTRL + select or SHIFT + select for multiple
devices) that the firmware should be assigned to. The row turns light gray.
NOTES:
l
If a device is not located in the Assignments section, select Show all Available
IDs.
l
If a deep sleep device has not been acquired by the gateway, assign the
firmware to an ID if the future ID number of the device is known.
7. In the Firmware Images section, select the firmware that should be assigned to the device
(s). The row turns light gray.
8. Once the device(s) and firmware are selected, select Assign Selected Image to Selected
Target(s) to assign the firmware to the device(s). The firmware is stored on the gateway
and assigned to the device(s).
9. Select a method to initiate the firmware upgrade on the GLS-OIR-CSM-EX-BATT:
l
Allow the GLS-OIR-CSM-EX-BATT to automatically initiate the firmware upgrade,
which occurs every 24 hours.
l
To manually initiate the firmware upgrade, enter or exit the room—the occupancy
sensor initiates the firmware upgrade once it detects occupancy or vacancy.
To Next Page
Loading...
