Crestron HD-MD6X2-4K-E - Page 13

Supplemental Guide – DOC. 7761A HD-MD-6X2/4X2/4X1-4K-E: 4K HDMI Switchers
•
9
NOTE:
The Output page varies depending on the model of the switcher.
The Output page shown on the preceding page applies to the HD-MD6X2-4K-E,
which has six inputs and two outputs. For the HD-MD4X2-4K-E, the Output page
lists four inputs and two outputs. For the HD-MD4X1-4K-E, the Output page lists
four inputs and one output.
2. For each output, do the following as appropriate:
a. In the
Route
drop-down list, select
0: <clear Route>
to clear a route to
the output, or select the desired input to set a route.
The
Transmitting
icon indicates whether an HDMI signal is being
transmitted to the output:
• A green icon indicates that an HDMI signal is being transmitted to
the output.
• A gray icon indicates that an HDMI signal is not being transmitted
to the output.
b. In the
Name
text entry box, rename the output if desired.
c. In the
HDCP Output
drop-down list, select one of the following:
•
Auto:
(Default setting) Specifies that the output be encrypted if the
input requires HDCP protection
•
Always Enabled:
Specifies that the output always be encrypted
regardless of the input requirements
d. Do one of the following:
• Click
Save
to save the
Route
,
Name
, and
HDCP Output
entries
for each corresponding output.
• Click
Revert
to go back to the previous settings without saving the
current entries.
• Click
Save All
to save all unsaved entries.
The Output page also displays the following information about the connected display:
•
Manufacturer:
Specifies the name of the manufacturer of the connected display
•
Model:
Specifies the model name of the connected display
•
Serial Number:
Specifies the serial number of the connected display