Crestron Horizon HZ-THSTAT - Overview

Thermistor Curve
The thermostat is compatible with Crestron remote sensors and 10K
thermistors. Refer to the table for information on the supported
thermistor temperature curve.
Temperature k-ohm
-30°F (-34.4°C) 185.42
0°F (-17.8°C) 81.72
40°F (4.4°C) 26.11
80°F (26.7°C) 9.37
90°F (32.2°C) 7.41
110°F (37.8°C) 4.75
120°F (48.9°C) 3.98
Wiring Diagrams
The following diagrams are a sampling of possible wiring solutions and
do not represent all wiring options.
l
Single Stage Heat-Only System without Common Wire
l
Single Stage Heat/Cool System without Common Wire
l
Single Stage Heat/Cool System
l
Single Stage Heat Pump with Aux Heat
l
Dual Stage Heat/Cool System with Separate References and
Humidification
l
Wiring a Local Power Source
After wiring the thermostat, plug the wire hole on the back of the
thermostat with the included foam insulation. The insulation prevents
drafts and ensures accurate temperature readings.
NOTE: For Radiant Floor, if the Radiant type is Floor Warming, Space
Heating, or Floor Warm/Space Heat, always connect the radiant floor
call wire to W2. Space Heating or Floor Warm/Space Heat will always
use the radiant floor as the first stage of heat.
8
HZ-THSTAT
QuickStart
Horizon® Wireless Thermostat