Isys
®
5.7” Wall Mount Touchpanel Crestron TPS-6L
Touchpanel Removal
If it is necessary to remove the touchpanel after it has been installed into a mounting
surface, complete the following steps in the order provided to remove the
touchpanel. The only tool required is a #2 Phillips tip screwdriver.
1. Lift one edge of the bezel to free it from the touchpanel, and lift it off. Do
not apply excessive pressure to the touchscreen.
2. Loosen and remove the screws that secure touchpanel to the mounting
option in use.
3. Using equal pressure, carefully remove the touchpanel from the opening.
If necessary, secure and label the attached cables before disconnecting them from the
back of the touchpanel.
Hardware Hookup
Ventilation
The TPS-6L should be used in a well-ventilated area. The venting holes should not
be obstructed under any circumstances. If the TPS-6L is hot to the touch, consider
used forced air ventilation.
To prevent overheating, do not operate this product in an area that exceeds the
environmental temperature range listed in the table of specifications. Consideration
must be given if installed in a closed or multi-unit rack assembly since the operating
ambient temperature of the environment may be greater than the room ambient
temperature. Contact with thermal insulating materials should be avoided on all sides
of the unit.
Connect the Device
Make the necessary connections as called out in the illustration that follows this
paragraph. Refer to “Network Wiring” on page 12 before attaching the 4-position
terminal block connector. Apply power after all connections have been made.
When making connections to the TPS-6L, use Crestron power supplies for Crestron
equipment.
34 • Isys
®
5.7” Wall Mount Touchpanel: TPS-6L Operations & Installation Guide - DOC. 6630A
To Next Page
Loading...
Need help?
General
