Crestron TSW-552/752/1052 5”/7”/10.1” Touch Screens
Configuration Guide – DOC. 7578A 5”/7”/10.1” Touch Screens: TSW-552/752/1052
3
Configure the Touch Screen
Ethernet Setup
On the “TSW-x52 Setup” menu, touch Ethernet Setup to display the “Ethernet
Setup” menu.
“Ethernet Setup” Menu
The “Ethernet Setup” menu displays the touch screen’s Mac and IP Address, Subnet
Mask, Def Router, Primary DNS, Secondary DNS, Hostname, and Domain. There are
controls for turning DHCP On or Off and, when DHCP is off, a Set Static IP
Address Settings button, which provides access to controls which allow editing of
these settings. This screen also contains a Link indicator to show the status of the
Ethernet connection.
DHCP is enabled by default. To change to a static IP address, touch Off under
DHCP Enabled, then touch Set Static IP Address Settings to display the “Ethernet
Setup – Static IPs” screen.
“Ethernet Setup – Static IPs” Screen
To Next Page
Loading...
