Crestron TSW-560 - Web Configuration

Product Manual — Doc. 7927K TSW-560, TSW-760, and TSW-1060 • 27
Web Configuration
The touch screen may be monitored and configured using the included web configuration
interface. The configuration interface is accessible from a web browser if the touch screen IP
address is known. This interface is also accessible using the XiO Cloud® service.
To access the configuration interface:
1. Use the Device Discovery tool in Crestron Toolbox™ software to discover the touch screen
and its IP address on the network.
2. Open a web browser.
3. Enter the touch screen IP address into the browser URL field. The configuration interface is
displayed (TSW-1060 shown).
NOTE: If authentication is enabled for the touch screen, an administrator username and
password must be entered prior to accessing the web configuration interface. For more
information on configuring authentication settings, refer to AuthenticationManagement
(on page42).
Web Configuration Interface
The configuration interface provides a Status tab for monitoring touch screen settings and a
Settings tab for configuring touch screen settings and for selecting a touch screen application.
The device hostname is displayed at the top left of the page.
NOTE: Some device settings may be displayed or hidden depending on the selected application
mode.
If the Crestron room scheduling application is running on the touch screen, the web configuration
utility provides additional configuration options for the room scheduling application. For more