Product Manual — Doc. 7927K TSW-560, TSW-760, and TSW-1060 • 57
Control System
Click Control System to configure a connection to a Crestron control system.
NOTE: The Control System accordion is shown in user project mode only.
Settings Tab - Control System
l Encrypt Connection: Fill the switch to turn on an encrypted connection to the control
system.
l Username: If Encrypt Connection is enabled, enter a username for the encrypted
connection.
l Password: If Encrypt Connection is enabled, enter a password for the encrypted connection.
l Confirm Password: Reenter the password set for Control System Password.
l IP Table: Set an IP table connection between touch screen and control system:
o
IP ID: Enter an IP ID for connecting the touch screen to the control system.
o
IP Address/Hostname: Enter the control system IP address or hostname.
o
Room ID: Enter a room ID to associate with the touch screen (for connections with
the Crestron Virtual Control server-based control system)
NOTE: For more information on connecting the touch screen to Crestron Virtual Control,
refer to the help file in the Crestron Virtual Control web configuration interface. To access
the help file, click the question mark button on the top left of the page.
To Next Page
Loading...
Need help?
General
