EasyManua.ls Logo

Cricket SL101AE - Installing SIM and SD Cards

Cricket SL101AE
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Charge using the AC adapter
1. Connect one end of the data cable to the USB port located on the bottom of your phone.
2. Connect the other end to the power adapter.
3. Connect the power adapter to an electrical outlet to fully charge your phone.
Use the power adapter that comes with your phone; using other adapters may damage your phone.
Charging your phone with a USB cable connected to a laptop will take longer than with the power adapter.
The phone will power off automatically when the battery is too low. Charge the battery if this happens. When the battery is critically
low, the phone may need a few minutes to build a charge before turning back on. Playing games or performing other activities while
charging may drain the battery and cause it to power off.
The battery will gradually discharge if it is left unused for a long period of time. Before using the battery again, you must recharge it in
order to power on and use your phone normally.
Install a SIM/SD Card
Insert a Nano SIM/microSD card
1. From the back of the phone, insert a fingernail into the small slot at the bottom left corner and firmly pull up to remove the back cover.
NOTE: The back cover cannot be removed while the charger is plugged in.
2. On the back of the phone, slide the Nano SIM card into the SIM card slot at the top left of the phone with the gold contacts facing down.
3. Slide the microSD card into the SD card slot at the top right of the phone.
4. Replace the back cover and press firmly around the sides and all four corners until it snaps into place.
Mount an SD card
1. With an SD card inserted, swipe up from the Home screen to access Apps and tap Settings.
2. Tap Storage> SD CARD.
3. Tap MOUNT on the prompted screen.
Unmount an SD card
Always unmount an SD card before removing it from your phone to avoid corrupting or damaging the files on the SD card.
1. From the Home screen, swipe up to access Apps and tap Settings.
2. Tap Storage>.
Your SD card is now safely unmounted. To use this SD card again, you will need to remove (see below) and mount it again.
Remove an SD card
1. From the back of the phone, insert a fingernail into the small slot at the bottom left corner and firmly pull up to remove the back
cover.
NOTE: The back cover cannot be removed while the charger is plugged in.
2. On the back of the phone, slide the microSD card out of the SD card slot at the top right of the phone.
Format an SD card
When you insert an optional SD card for the first time, it is recommended that you format it on your phone.
Note: Formatting your SD card will erase all files on the card. Make sure to back up your files in another location before formatting.
1. From the Home screen, swipe up to access Apps and tap Settings.
2. Tap Storage > SD CARD.
3. Tap Menu > Storage settings.
4. Select Format or Format as internal, then tap FORMAT SD CARD to confirm.
All data on the SD card will be erased, and the card will be formatted for use on your phone.

Table of Contents

Related product manuals