Crivit Z30341 - Backlight

23 GB
Use
j Press the SCAN button
5
to activate the station search. The
station search stops as soon as it picks up a station. Press the
SCAN button
5
again to resume the station search.
Note: The station search stops as soon as it reaches 108 MHz.
j Press the RESET button
7
to reset the station search to 88 MHz.
Note: You can reset the station search to 88 MHz at any
time by pressing the RESET button
7
.
Q
Backlight
j Press one of the following buttons to turn on the backlight:
1
CLEAR button
2
FUNC button
3
SET button
4
MODE button
The backlight will light up for approx. 5 seconds after releasing
the button.