EasyManua.ls Logo

Cromtech AP110002 - Maintenance

Default Icon
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
CROMTECH Operation & Instruction Manual
AP110002 MAINTENANCE
WARNING: Disconnect the unit from power before servicing or cleaning. Replace all safety grills
after servicing or cleaning
POWER CORD:
Visually inspect cord and plug head before use. If there are signs of damage or excessive wear,
discontinue use until the unit has been serviced.
CLEANING:
The housing is made of durable and washable polypropylene. When cleaning, the use of solvents is
NOT recommended. When washing inside the unit, disconnect the unit from its power source.
Protect the switch, receptacle, and circuit breaker from water intrusion. Do not spray water or
cleaning solution at motor. If motor does get wet, allow motor to dry completely before restarting. If
fan is to be washed and not used within 24 hours, allow fan to drip dry for 10 minutes and then run
for 5 minutes before storing.
IMPORTANT: Do NOT remove impeller blade from motor assembly. Doing so can cause blade to
become imbalanced upon re-assembly.
SERVICE:
CAUTION: Servicing the Cromtech Carpet Dryer with its high voltage circuitry presents a health
hazard that could result in death, serious bodily injury, and/or property damage. Disconnect the
appliance from the power supply before servicing. Only qualified service people should service this
unit.
CAUTION: If the supply cord becomes damaged, they must be replaced by the manufacturer, its
service agent or similarly qualified person to avoid a hazard.