AP160016 OPERATION
1. Plug in to a standard outlet with the correct voltage and amperage for the unit.
2. Place the dryer in the desired operating position.
3. Set the switch at the desired speed: low or high.
4. Check for proper operation before leaving the unit unattended.
NOTE: Do not move or carry the dryer when it is running.
10 AMP RESETTABLE CIRCUIT BREAKER
The Cromtech Down Draft Blower features a 10 amp circuit breaker that will "trip" if more than 10
amps of electrical current drawn through the cord.
OPERATING POSITIONS
The Down Draft Blower is designed to operate in multiple positions for any type of drying.
1. Tilt Back - Tilt the Blower backward on the four curved moulded legs at an angle to direct air
for elevated drying
2. Upright - Set the Blower square with the handle on the top to direct air across a room
3. Tilt Forward - Tilt the Blower forward on the "standing legs at an angle to direct airflow
along the flow in front of the dryer
4. Face Down - Set the Blower on the four curved moulded legs with the "standing legs" facing
up to direct air straight down
5. Power Pitch - The Blower is equipped with a 3° down angle leg
6. Stack for Storage - The Blower interlock and stack for easy storage and transport.
To Next Page
Loading...