AP110020 CROMTECH™ MULTI AIR MOVER
WARNING To reduce the risk of fire,
electric shock, or injury:
1. Read the manual carefully and
completely before attempting to
operate the unit. This manual has
important information for the use
and safe operation of the machine.
Following the recommendations
outlined in this manual will assure
years of satisfactory service from
your unit
2. Improper connection of the
equipment grounding conductor
can result in a risk of fire, electrical
shock, or personal injury. Always
use a three-wire electrical system
connected to the electrical ground.
For maximum protection against
electrical shock, use a circuit that is
protected by a ground fault circuit
interrupter. Check with a qualified
electrician or service person if you
are in doubt as to whether your
outlet is properly grounded. Do not
use a unit with a damaged cord or
plug.
3. Machines can cause an explosion when near flammable materials and vapours. Do not use
or store this machine with or near fuels, grain dust, solvents, thinners, or other flammable
materials. Do not use flammables to clean this machine.
4. Do not immerse or use this unit in standing water. Such use may cause electrical shock. To
avoid electrical shock, do not expose the unit to rain – store it indoors only. Do not expose
the unit to freezing temperatures.
5. Do not move or carry the unit when it is turned on. Do not pull or carry by the cord, use cord
as a handle, close a door on the cord or pull cord around sharp edges or corners. Keep cord
away from heated surfaces. Do not unplug cord by pulling on it. To unplug, grasp plug, not
the cord. Do not handle plug or air mover with wet hands.
6. Do not put any objects into openings. Do not use with any opening blocked; keep free of
dust, lint, hair, and anything that may reduce air flow. Keep hair, loose clothing, fingers, and
all parts of the body away from openings and moving parts.
7. Turn off all controls before unplugging.
8. Operate unit on a level and stable surface to prevent it from falling and possible cause of
injury or damage.
9. Do not drop or throw the unit. Treatment of this type can cause damage to the components
and create hazardous conditions.
To Next Page
Loading...