2.30
Pinto BT-POM 1212 - Revision 5
Pre-OperationPre-Operation Check - 2000 Litre
(e) Use the “-” key to reduce the
pressure to your normal spraying
pressure - 2-4 BAR (30-60 psi).
8 Check the tank agitator valve is open.
9 Visually check that both tank
agitators are working.
10 Turn the Controller Master switch ON
& OFF and check that all boom
sections are switched off together.
11 Turn fenceline* nozzle ON & OFF to
check it is working correctly (*if fi tted)
12 While water is being pumped
through the boom, check for any
leakages or blockages throughout
the sprayer.
Check all hoses, connections,
valves, fi lters, boom fi ttings etc.
Check the nozzles are operating
correctly.
Rectify any problems.
13 With all boom operating, re-check
pressure range by alternating from
“+” to “-” on the Spray Controller while
in MANUAL mode.
Ensure maximum pressure does not
exceed 8 BAR. Minimum pressure
should reach almost zero.
14 Switch booms ON & OFF several
times, ensuring each section is
operating individually, and that the
non-drip nozzle bodies are working.
15 On completion of checking the
sprayer, turn controls Off by placing
the master switch and boom
switches in OFF position.
16 Disengage PTO or Hydraulic pump
drive after the Spray Controller
is switched off.
The maximum spraying pressure will vary with
different nozzles.
We recommend you re-adjust your maximum
pressure if you change your nozzle selection.
NOTE
+/- keys and auto/man key. Boom switches Off; Master switch in Hold.(8) Check the Agitator Valve is open & agitator
operating.
To Next Page
Loading...