Fig. 11 EMPTYING DRUM
Spiral
23
NOTE
On the larger models, a full drum
can ll more than one wheelbar-
row. Change wheelbarrows until
the drum is empty.
Paddles
16. Capacities:
Each model has its own specied capacity.
When that capacity is exceeded, the excess spills out
of the drum making a mess of the working area and
increases the required time for mixing. It is recom-
mended to use an additional mixer if more mixing
capacity is required.
Table 1 Capacity Bags
4S
5S
S5S
1 - 1-1/2
6S
6SR
S6SR
6PR
2 - 2-1/2
S8S
8S
8P
3 - 3-1/2
10S
S10S
12S
S12S
3 - 4
1. Read and understand Operator's Manual and safety signs
before starting.
2. Stop engine, disconnect spark plug wire and wait for all
moving parts to stop before servicing, maintaining, adjust-
ing or cleaning.
3. Keep hands, feet, hair and clothing away from moving parts.
4. Install, close and secure all guards, shields and hoods before
operating.
5. Do not place hands in the drum unless engine is OFF and
spark plug wire is disconnected.
6. Stay away from hot engine components during operation.
7. Do not smoke when refueling.
8. Follow good safety procedures when handling fuel.
9. Do not operate in an explosive atmosphere or a poorly
ventilated area without adequate ventilation.
10. Keep working area dry and clean to prevent slipping and
tripping.
11. Always attach safety chain when towing.
12. Comply with applicable transporting regulations when tow-
ing.
13. Do not allow riders during transporting.
14. Do not exceed a safe travel speed when transporting. Slow
down for corners and when going over rough terrain.
201001
WARNING
G
To Next Page
Loading...
