Crown 4S - General Safety; Operating Safety

2
• Mixerownersmustgiveoperatinginstructions
to operators or employees before allowing them
to operate the machine, and at least annually
thereafter.
• Themostimportantsafetydeviceonthisequip-
ment is a SAFE operator. It is the operator’s
responsibility to read and understand ALL Safety
and Operating instructions in the manual and to
follow these. All accidents can be avoided.
• Apersonwhohasnotreadandunderstoodall
operating and safety instructions is not qualied
to operate the machine. An untrained operator
exposes himself and bystanders to possible seri-
ous injury or death.
• Donotmodifytheequipmentinanyway.
Unauthorized modication may impair the
function and/or safety and could aect the life
of the equipment.
2.1 GENERAL SAFETY
1. Read and understand the
Operator's manual and all
safety signs before
operating, maintaining,
adjusting, servicing or
cleaning the Mixer.
Only trained competent persons shall operate the
Mixer. An untrained operator is not qualied to
operate the machine.
Have a rst-aid kit available for use,
should the need arise and know how
to use it.
Do not allow riders when towing.
Have a re extinguisher available for use
should the need arise and know how to use
it.
Wear appropriate protective gear. This list
includes, but is not limited to:
- A hard hat
- Protective boots
with
slip resistant soles
- Protective goggles
- Heavy gloves
- Hearing protection
2.
3.
4.
5.
6.
Stop engine, disconnect spark plug wire and
wait for all moving parts to stop before servicing,
adjusting, repairing or cleaning.
Wear appropriate hearing protection when
operating for long periods of time.
Dust Hazard ~ Wear appropriate dust
mask around this equipment.
Ventilation ~ Never operate any
gas powered equipment in a poorly
ventilated or enclose area. Avoid
prolonged breathing of exhaust
gases.
Hot Surface ~ Avoid contact with hot
exhaust system and engine.
Allow to cool before performing
repairs or service.
7.
8.
9.
10.
11.
2.1 GENERAL SAFETY
Electrocution Hazard ~ Always
use proper size grounded
extension cord. Inspect all
extension cords for cuts, frayed
wire and broken connectors.
Do not use cords if not in good
condition.
12.
13. Do not refuel the ma-
chine while
smoking or when
near open ame or sparks.
2.2 OPERATING SAFETY
1. Read and understand the Operator’s Manual and all
safety signs before operating, servicing, adjusting, or
cleaning the Mixer.
2. Do not allow riders on the machine during transport.
3. Install, close and secure all guards, shields and hoods
before starting or operating.
4. Stop engine or motor, disconnect spark plug wire or
unplug power cord, and wait for all moving parts to
stop before servicing, adjusting, repairing, or clean-
ing.
Discount-Equipment.com