Crown 4S - Tire Safety; Storage Safety; Refueling Safety; Electrical Safety

2.7 REFUELING SAFETY
1. Handle fuel with care. It is highly ammable.
2. Allow engine to cool for 5 minutes before re-
fueling. Clean up spilled fuel before restarting
engine.
3. Do not refuel the machine while smoking or
when near open ame or
sparks.
4. Always use an approved fuel
container.
2.8 ELECTRICAL SAFETY
1. Have a licensed electrician wire up and supply
power to the electric motor.
2. Always use a grounded power cord with the re-
quired capacity to carry the power to the motor.
3. Route the power cord out of the way or protect
from damage.
5. Fill fuel tank outdoors.
6. Prevent res by keeping machine clean of accu-
mulated trash, grease and debris.
5
2.5 TIRE SAFETY
1. Failure to follow proper procedures when mount-
ing a tire on a wheel or rim can produce an explo-
sion which may result in serious injury or death.
2. Do not attempt to mount a tire unless you have the
proper equipment and experience to do the job.
3. Have a qualied tire dealer or repair service per-
form required tire maintenance.
2.6 STORAGE SAFETY
1. Store unit in an area away from human activity.
2. Do not permit children to play on or around the
stored Mixer.
6. Use a mechanical retainer through the ball hitch or
clevis pin before transporting.
7. Ensure wheel nuts and axle hardware are tight.
4. Turn motor o, unplug power cord or turn o
power at master panel and wait for all moving
parts to stop before servicing, maintaining, ad-
justing or cleaning.
5. Keep all electrical components in good condi-
tion.
2.9 SAFETY SIGNS
1. Keep safety signs clean and legible at all times.
2. Replace safety signs that are missing or have become
illegible.
3. Replaced parts that displayed a safety sign should
also display the current sign.
4. Safety signs are available from your Distributor or the
factory.
How to Install Safety Signs:
• Besurethattheinstallationareaiscleananddry.
• Decideontheexactpositionbeforeyouremove
the backing paper.
• Removethesmallestportionofthesplitbacking
paper.
• Alignthesignoverthespeciedareaandcarefully
press the small portion with the exposed sticky
backing in place.
• Slowlypeelbacktheremainingpaperandcarefully
smooth the remaining portion of the sign in place.
• Smallairpocketscanbepiercedwithapinand
smoothed out using the piece of sign backing
paper.
2.10 SIGN-OFF FORM
Crown Construction Equipment follows the general
Safety Standards specied by the Society of Automo-
tive Engineers (SAE) and the Occupational Safety
and Health Administration (OSHA). Anyone who will
be operating and/or maintaining the Crown Mortar
Mixer must read and clearly understand ALL Safety,
Operating and Maintenance information presented in
this manual.
Do not operate or allow anyone else to operate this
equipment until such information has been reviewed.
Annually review this information before the season
start-up.
Discount-Equipment.com