29
2. On gas engine powered units, open the
hood and close the fuel valve to prevent
ooding the carburetor.
3. Move the drum to its mixing position and
lock.
4. Attach the optional lighting bar and se-
cure.
5. On the larger Models, extend the hitch
pole and secure with the lock pin and
retainer.
6. Securely attach the machine to the towing
Machine is shown with engine hood open
for illustrative purposes only. Never oper-
ate with hood open.
Fig. 16 FUEL SHUT OFF VALVE
WARNING
vehicle.
7. Use a mechanical retainer through the
ball hitch or the clevis pin.
8. Attach the safety chain to prevent un-
expected separation. Cross the chains
under the hitch for support.
9. Plug the wiring harness into the truck.
Be sure all the lights are working.
10. Check that the wheel bolts are tight-
ened to their specied torque.
11. Check that the tires are inated to
their required pressure.
12. Use special care when transporting
during times of limited visibility. Be
sure that you can be seen by oncom-
ing and overtaking trac. Always use
the lighting bar.
13. Never exceed the speed appropriate
for the terrain and conditions. Slow
down for turns and when traveling
over rough terrain.
Fig. 17 ATTACHMENT
Clevis
IMPORTANT
Be sure the ball on the truck is
the correct size for the hitch. Do
not use an undersized ball with
the hitch.
Ball Hitch
To Next Page
Loading...
