Crown C-5 Series - Capacity Plate; Capacity Plate Information; Reading Capacity Plates (Post-Aug 2017); Reading Capacity Plates (Pre-Aug 2017)

21
20
Serial Number Truck Type
Attachment Data
8586-A
Load
Center
Truck Weight, Less Load, with
Attachment 5
Capacity with Mast Vertical
Capacity
C A
kg (lb) mm (in)
mm (in)
kg(lb)
C
A
Capacity Plate
Capacity Plate
Capacity Plate
CAPACITY PLATE INFORMATION
The capacity plate is on the overhead guard. It contains:
• Truck serial number
• Capacity information (load, load center and lift height)
• Truck type (a fire safety rating)
• Truck weight, Less Load, with Attachments 5%
• Attachment information (if any)
AFTER AUGUST 2017: READING YOUR CAPACITY PLATE
Capacity may be reduced as lift height increases.
For example: On the sample plate, 1815kg (4000 lb)
can be lifted to 4775mm (188 in). But above 4775 (188),
to 5230 (206), capacity is reduced from 1815 (4000) to
1745 (3850).
Capacity is reduced as load center increases.
For example: On the sample plate, 1815kg (4000 lb) can
be lifted if the load center is 600mm (24 in). But if the load
center is increased to 750mm (30), capacity is reduced
from 1815 (4000) to 1450 (3200).
Caution: You may not increase capacity if load center is
less than shown on your capacity plate.
Note: ANSI/ITSDF B56.1 requires that all data be shown
first in Metric units and then USA units.
SAMPLE
CAPACITY PLATE
The information
shown on this sample
plate does not apply
to your truck.
Know the Hazards
OTHER LIFT HEIGHTS & LOAD CENTERS
Contact Crown for capacities at lift heights or load centers not
given on your capacity plate.
TRUCK WEIGHT
Dockboards, elevators and some floors have limited
capacity. Check your capacity plate for the weight
of your truck. Remember to add the weight of the
load you have on the forks. Make certain you use the
correct units of measure.
TRUCK TYPE
Some truck types are not permitted in areas where
there are fire hazards. Watch for marked areas. For
example: You must not drive a type LP or D truck into an
area restricted to LPS or DS trucks.
ATTACHMENT DATA
If an attachment on your truck does not match the
information given on your capacity plate, don't operate
your truck. Your capacity plate may be wrong. Report
the problem to your supervisor.
BEFORE AUGUST 2017: READING YOUR CAPACITY PLATE
Capacity may be reduced as lift height increases. For example: On the sample
plate, 1815kg (4000 lb) can be lifted to 4775mm (188 in). But above 4775 (188), to 5230
(206), capacity is reduced from 1815 (4000) to 1745 (3850).
Capacity is reduced as load center increases. For example: On the sample plate,
1815kg (4000 lb) can be lifted if the load center is 600mm (24 in). But if the load center
is increased to 750mm (30), capacity is reduced from 1815 (4000) to 1450 (3200).
Caution: You may not increase capacity
if load center is less than shown on
your capacity plate.
Note: ANSI/ITSDF B56.1 requires that
all data be shown first in Metric units
and then USA units.
8586-A
Load
Center
Capacity with Mast Vertical
Units of measure, kg/mm(lb/in)
Capacity
A B
kg (lb) mm (in) mm (in)
A
B