Lower Floor Vent
Windshield Vent
Accessory Power Outlet
Upper Floor Vent
Right Door Lever
Fan Switch
Heater Control
Window Latch
15
14
Hard Cab
option
Hard Cab
option
Hard Cab option
DOOR OPERATION
To enter the cab, pull the handle to open the door.
Climb aboard your truck and close the door before
you start the vehicle.
To exit, grab the door handle grip and slide it
backward. Push the door to open.
Close the doors after leaving the cab.
HEAT AND VENTILATION CONTROL
• Set the fan switch to the desired speed.
• Adjust the Heater Control to increase or decrease the
temperature in the cab.
You can use the fan switch to circulate air throughout
the cab. The vents are fully adjustable and can be used
to direct the air where you want it.
WINDSHIELD DEFOG AND DEFROSTING
Turn on the heater and fan switch, and adjust the vents
to defog/defrost the windshield before you drive your
truck. Once the windshield is defrosted, use your
windshield wiper to clear your windshield.
USE YOUR TRUCK SAFELY
Do not open the door while the truck is moving.
Head, arms, hands, legs or feet outside an open door
could be crushed or even cut off whenever the truck
is moving. Keep the door closed and
stop the truck
completely before getting off.
You can be trapped or crushed by objects protruding
or poking into the operator area. The heated cab glass
will not stop a protruding object.
Look where you are
going.
Know the Hazards
To Next Page
Loading...