Raise/Lower, Tilt & Accessories 1817 Power On & Off
KEY SWITCH
• Turn the key clockwise from the red dot to the
yellow dot to start the engine. Check that the seat
alarm and all indicator lights are working.
• Let go of the key and it will return to ON (green dot).
• Turn the key counterclockwise to OFF (red dot) to
shut the truck off. Always turn the key to OFF when
leaving the truck. Apply the parking brake.
CARBON MONOXIDE POISONING
Don’t inhale the engine exhaust. It contains carbon
monoxide which is a colorless and odorless gas. It
can cause unconsciousness or even death with little
or no warning.
Don’t operate the truck in unventilated areas where
the exhaust gas can accumulate.
HYDRAULIC OPERATIONS CAN AFFECT STABILITY
Capacities shown on your capacity plate are for loads
that are centered and level. Be extra careful when
tilting a load. (This also applies to accessories or
attachments your truck may have such as sideshift,
carton clamp, push-pull, etc.)
For example: Pull the Raise/Lower lever toward
you to raise the forks, as shown by the symbol.
Push the lever away from you to lower the forks.
LIFT AND TILT INTERLOCK
Lift and Tilt are interlocked so that you cannot lift higher
than 95” to 102” (depending on mast height) if the mast
is tilted forward past 2º, or tilt the mast forward past 2º
if you have lifted higher than 95” to 102”.
Note:
You must use full engine speed (with the inching/
brake pedal applied; see page 15.) to obtain maximum
performance for any hydraulic operation.
Raise/Lower lever
Tilt lever
Accessory levers (optional)
HYDRAULIC LEVER OPERATION
Pull a lever toward you, away from the mast, and you'll
get the action shown by the symbol in the top of the
lever. Push the lever away from you, toward the mast,
and you'll get the opposite action.
The farther you move the lever from neutral, the faster
the action will be.
Power On & Off Raise/Lower, Tilt & Accessories
Know the Hazards
Know the Hazards
To Next Page
Loading...