To Next PageTo Next Page
Need help?Do you have a question about the Crown CE-2000 and is the answer not in the manual?
General| Signal to Noise Ratio | > 100 dB |
|---|---|
| Total Harmonic Distortion | < 0.5% |
| Input Sensitivity | 1.4V |
| Channels | 2 |
| Frequency Response | 20Hz - 20kHz |
| Dimensions | 19" x 3.5" x 16.2" |
| Input Impedance | 20 kOhm balanced, 10 kOhm unbalanced |
Discusses magnetic field effects on sensitive equipment and rack placement recommendations.
Details FCC compliance rules, conditions, and measures for interference.
Lists European EMC and safety standards applicable to audio, video, and entertainment lighting control apparatus.
Lists key features of the CE Series amplifiers, including sound quality and protection.
Provides guidance on using the manual and recommends reading all instructions and warnings.
Instructions for unpacking, inspecting for damage, and saving packing materials.
Guidance on safely installing the amplifier in a rack and ensuring proper ventilation.
Details the three input connector choices (XLR, phone, barrier strip) and wiring methods.
Recommends speaker wire gauge based on distance and explains output connector options.
Describes how to wire the system for stereo mode, including input/output connections.
Explains methods for feeding the same signal to both amplifier channels.
Details wiring for bridge-mono mode, including input/output connections and mode switch.
Explains the function and adjustment of the two-position input sensitivity switch.
Instructions for connecting to AC power and the safe startup procedure.
Lists precautions for optimum performance and safety during operation.
Identifies and describes front and back panel controls, indicators, and connectors.
Explains the function of front panel controls and indicators like power switch, LEDs, and level controls.
Describes back panel controls like sensitivity/mode switches and connectors like inputs/outputs.
Details various built-in protection systems for the amplifier and loudspeakers.
Explains the bias servo system and how to monitor amplifier faults remotely.
Details protection against high frequencies and RF interference via controlled slew rate.
Explains drive protection from DC/subsonic signals and the speaker-protecting compressor.
Mentions the power circuit breaker reset and proportional fan speed control.
Introduces optional SST modules for improved fidelity and versatility, like active crossovers.
Details how to use the Fault jack for remote monitoring of amplifier status via an LED circuit.
Lists optional accessories like CE Handles and alternate output connectors (CEAS1, CEAS2).
Explains tamper-resistant plugs for controls and the optional 0.775V input sensitivity setting.
Addresses troubleshooting steps when the power indicator is off, listing possible reasons.
Addresses troubleshooting when the sound is distorted, including potential causes and solutions.
Addresses troubleshooting when there is no input signal, listing possible reasons.
Details troubleshooting steps when the fault indicator is flashing, listing potential causes.
Addresses troubleshooting when there is input signal but no sound, focusing on speaker connections.
Lists minimum guaranteed power output for CE 1000 and CE 2000 models under various impedance conditions.
Provides detailed performance specifications like frequency response, THD, S/N ratio, and damping factor.
Specifies load impedance, voltage gain, and idle power draw for the amplifiers.
Explains how to obtain service from an authorized service center worldwide.
Details service options within the US and Canada, either at a service center or the factory.
Outlines the procedure for obtaining service directly from the Crown factory, including shipping.
Summarizes the three-year warranty and lists items excluded from coverage.
Explains how Crown remedies defects and disclaims liability for consequential damages.
Details warranty service procedures for customers outside the USA and Canada.
Guides users on how to notify Crown and obtain warranty service for their product.
