To Next PageTo Next Page
Need help?Do you have a question about the Crown Macro-Tech 2402 and is the answer not in the manual?
Provides basic product details, language options, trademarks, and copyright notice.
Critical instructions for preventing electric shock, fire, and ensuring safe operation.
Advises on potential magnetic field interference and optimal rack positioning.
Details compliance with FCC rules, including interference and modification guidelines.
Lists specific EMC standards for emissions and immunity.
Specifies adherence to safety requirements for audio-video electronics.
Highlights core technologies like Grounded-Bridge, ODEP, PIP, and warranty.
Instructs users on how to effectively navigate and utilize the manual's content.
Procedures for unpacking, checking for damage, and saving packing materials.
Guidelines for physical installation, dimensions, and rack integration.
Details requirements for proper ventilation and heat dissipation.
Recommends input cable types and details connector pin assignments.
Advises on selecting appropriate speaker wire gauge and connectors.
Step-by-step guide for connecting speakers in stereo configuration.
Instructions for wiring the amplifier in bridged mono configuration.
Details how to wire and configure the amplifier for parallel-mono operation.
Explains how to set the input sensitivity switch for optimal gain.
Critical steps for connecting the amplifier to the AC power source safely.
Outlines the correct procedure for turning the amplifier on.
Important safety guidelines for operating the amplifier.
Identifies and explains the functions of all front panel elements.
Details the power cord and the stereo/mono/bridge mode switch.
Explains the reset switches and the Programmable Input Processor (PIP) module.
Describes various input/output connectors and the ground lift switch function.
Explains the meaning of the Enable and ODEP indicators.
Details how Signal/IOC indicators monitor signal presence and distortion.
In-depth explanation of Output Device Emulation Protection.
Describes how standby mode is activated and its protective functions.
Details the thermal protection for the unit's transformers.
Explains the role of fuses and circuit breakers in power supply protection.
Lists key technological advantages and design features of the amplifier.
Introduces the concept and purpose of PIP and PIP2 modules.
Step-by-step instructions for installing PIP and PIP2 adapter and modules.
Discusses optional fan blades for modified cooling and technician installation.
Details the accessory for securing front panel level controls.
Correlates indicator states with amplifier conditions for troubleshooting.
Explains ODEP, Grounded Bridge, and other advanced design elements.
Details the circuit operation and signal path for stereo mode.
Explains the circuit implementation for bridged mono mode.
Details the circuit operation and IOC behavior in parallel mono mode.
Lists minimum guaranteed power for various loads and modes.
Details frequency response, S/N, THD, IMD, and damping factor.
Specifies safe load impedances, voltage gain options, and AC mains voltage.
Lists the amplifier's physical dimensions and weight.
Presents power output data from tone burst tests across different configurations.
Lists power ratings for international units, including FTC continuous average.
Explains the equations used for power draw and thermal dissipation calculations.
Provides tables of calculated power draw, current, and thermal dissipation.
Emphasizes qualified service and provides initial contact points.
Details service center options and factory service requirements.
Outlines packing, SRA, and shipping instructions for factory service.
Explains procedures for estimate approval and payment for repairs.
Outlines the three-year, no-fault, transferable warranty coverage.
Lists items not covered by warranty and disclaims incidental damages.
Guides users on how to initiate and receive warranty service.
Details how to obtain warranty service internationally.
Addresses modifications to warranty terms and design updates.
Instructions for registering the product for warranty and support purposes.
Information required for returning a product for factory service.
Outlines methods for payment of service charges and repairs.
General