13
Operation and Display Panel
The operation and the LCD module, shown in the chart below, includes six indicators, six function keys, on/off
switch and a LCD display to indicate the operating status and input/output power information.
Indicators
LED Indicator Color Solid/Flashing Messages
Setting LED 1 Green Solid On Output powered by utility
Setting LED 2 Green Solid On Output powered by PV
Setting LED 3 Green Solid On Output powered by battery
Status
indicators
Green
Solid On Output is available in line mode
Flashing Output is powered by battery in battery mode
Green
Solid On Battery is fully charged
Flashing Battery is charging.
Red
Solid On Fault mode
Flashing Warning mode
Function Keys
Function Key Description
ESC Exit the setting
USB function setting Select USB OTG functions
Timer setting for the
Output source priority
Setup the timer for prioritizing the output source
Timer setting for the
Charger source priority
Setup the timer for prioritizing the charger source
Select To next selection
Enter To co nf ir m/enter the selection in setting mode
+
Press these two keys at the time to switch RGB LED bar for output
source priority and battery discharge/charge status
On/off switch
Function keys
Setting LED 3
Setting LED 2
To Next Page
Loading...