700 Series Installation Instructions TES1589 Iss.B Page 5
INTRODUCTION
This equipment leaves the factory set for 230V a.c. nominal, single phase 50/60 Hz. mains
supply. Where the mains voltage differs from this, it is essential that the equipment is
ordered for the specific voltage in your region.
The equipment should be stored and kept in a dry condition.
The trolley is supplied with all main parts (i.e. Computer, Gas Analyser etc.) fitted, with the
exception of the Keyboard, Mouse and Monitor. Details for fitting these items are covered in
this manual.
Carefully unpack all items and examine for damage. Check contents against the packing list
enclosed for any loss or discrepancy. Report any loss, breakage or discrepancy to the
supplier immediately.
IMPORTANT NOTE
Do not disconnect or reconnect any leads between the various parts of the trolley
without first SWITCHING OFF the mains supply; this does not include any
connections to the vehicle under test.
To Next Page
Loading...