Crystal Clean 2734 - Waterflow System Operation; Air Pressure Regulator Adjustment; Pneumatic Cylinder Speed Adjustment; Bag Filter TTF1 and TTF2 Maintenance

9
ULTRASONIC CLEANING SYSTEMS ULTRASONIC CLEANING SYSTEMS
By adjusting the regulators it is possible to change the
movement speed of the plataform.
This zone indicates the maximum weight that can be raised
with this machine.
BAG FILTER TTF1 AND TTF2
(IF INCLUDED)
Filtering process of the cleaning liquid to reduce contamination.
Regular checking and emptying of the lter bag and its
cleaning are recommended. When the lter gauge exceeds
1 bar, empty the reusable bag.
Every time the lter is opened, to return to operation it must
be purged through the valve located next to the manometer.
Orient the valve hose to the main tank or a can.
To change the lter bag, you must open the lter cover, close
the outlet (to the tank) and inlet (to the lter) valves and
drain it through the drain valve. Replace the bag and leave
everything as at the beginning and purge.
Do not drop small objects into the tank, they may reach
the pump and damage it.
Attention: do not open the lter when hot to avoid injuries.
WATERFLOW SYSTEM
(IF INCLUDED)
With this system, through the pump (described in section 8 of
the previous section), a circulation is created in the uid that
entrains all the oil and other residues that are on the surface
to an auxiliary tank.
With the valves in the open position the pump works to remo-
ve the oil from the main tank to the auxiliary tank. This is the
normal position that the machine should always have.
To extract the oil from the auxiliary tank, proceed as follows:
- Open the drain valve and install a bucket for the drainage of
the oil. This operation is most effective by applying it with low
ow rate in the injection. (This valve must always be closed
in case it is not performing this operation)
- Inject water (very slowly) through the valve located in the
lower part of the equipment (The amount of oil that comes out
will be smaller the less the injection of water into the tank).
AIR PRESSURE REGULATOR
(IF INCLUDED)
In the equipment there is the possibility of regulating the
pressure of the compressed air (see the manometer) of the
pneumatic system of the platform or any other system that
requires air.
ADJUSTING THE SPEED OF THE PNEUMATIC
CYLINDER
(IF INCLUDED)