nVision Operation Manual • Page 43
.X
Accuracies,.Ranges.and.Resolutions
PSI bar kPa/MPa kg/cm2 Overpressure PSI kg/cm2 inHg
inH20
*
mmHg mmH20 kPa bar mbar MPa
30PSI
3.0 x 0.001 0.0001 0.001 0.01 0.01 1 0.01 0.0001 0.1
3BAR
3.0 x 0.001 0.0001 0.001 0.01 0.01 1 0.01 0.0001 0.1
300KPA
3.0 x 0.01 0.0001 0.1
3KG 3.0 x 0.001 0.0001 0.001 0.01 0.01 1 0.01 0.0001 0.1
100PSI
2.0 x 0.001 0.0001 0.01 0.1 0.1 1 0.01 0.0001 0.1 0.00001
10BAR
2.0 x 0.001 0.0001 0.01 0.1 0.1 1 0.01 0.0001 0.1 0.00001
1MPA
2.0 x 0.01 0.0001 0.1 0.00001
10KG 2.0 x 0.001 0.0001 0.01 0.1 0.1 1 0.01 0.0001 0.1 0.00001
300PSI
2.0 x 0.01 0.001 0.01 0.1 0.1 0.1 0.001 1 0.0001
30BAR
2.0 x 0.01 0.001 0.01 0.1 0.1 0.1 0.001 1 0.0001
3MPA
2.0 x 0.1 0.001 1 0.0001
30KG 2.0 x 0.01 0.001 0.01 0.1 0.1 0.1 0.001 1 0.0001
1KPSI
2.0 x 0.1 0.001 0.1 0.1 0.001 0.0001
100BAR
2.0 x 0.1 0.001 0.1 0.1 0.001 0.0001
10MPA
2.0 x 0.1 0.001 0.0001
100KG 2.0 x 0.1 0.001 0.1 0.1 0.001 0.0001
3KPSI
1.5 x 0.1 0.01 0.1 1 0.01 0.001
300BAR
1.5 x 0.1 0.01 0.1 1 0.01 0.001
30MPA
1.5 x 1 0.01 0.001
300KG 1.5 x 0.1 0.01 0.1 1 0.01 0.001
10KPSI
1.5 x 1 0.01 1 0.01 0.001
700BAR
1.5 x 1 0.01 1 0.01 0.001
70MPA
1.5 x 1 0.01 0.001
700KG 1.5 x 1 0.01 1 0.01 0.001
* Density of water can be set to 4°C, 60°F or 20°C /68°F with CrystalControl software .
0.025%
of Reading
modules
0.05%
of Reading
modules
0.1%
of Reading
modules
These pressure ratings also serve as part numbers when ordering nVision pressure modules.
For instance, the part number for nVision with a RTD100 temperature module in the upper bay
and a 30MPa pressure module in the lower bay would be:
NV-4AA-RTD100-30MPA (see Module Numbering System on page 25).
Dierential Pressure Mode adds one digit of resolution to each unit. Not all units are appropriate
for DP measurement due to noise oor. See Dierential Pressure section for details.
(30–100%
of Full Scale)
(30–100%
of Full Scale)
(30–100%
of Full Scale)
To Next Page
Loading...