nVision Operation Manual • Page 3
nVision Reference Recorder shown.
All instructions on this spread are also applicable to
nVision Lab Reference
Upper Module Bay
Back button:
Previous Display Screen
LED Indication alerts:
: Flashes while recording
(Flashes quickly when recording ends)
: Flashes when an overpressure
condition occurs
Record button:
Start/Stop data recording
(Adjust Logging Interval)
Power button:
Turn your nVision on/o
Lower Module Bay
Setup Button:
Locate additional features:
• Clear Peaks
• Units (Adjust Available units)
Settings
• Contrast
• Lock/Unlock Chassis
Summary
• Chassis, Upper, Lower
Recording
• Start/Stop
• Erase All Runs
This icon represents a component that can be
modied with CrystalControl software
To Next Page