EasyManua.ls Logo

Crystal VAPURE - Power and Boost Controls; Power;Mode Selection

Crystal VAPURE
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6. CONTROL PANEL OPERATION
13
6.2 POWER/MODE
Pressing [<] returns you to the DDS screen.
[POWER] button changes the operating modes of your
wered on the factory setting is in AUTO as shown to the right.
Pressing [<] returns you to the DDS screen.
Press [OK] to enter POWER/MODE.
Pressing [OK] enters the display shown to the right and pressing the [+] or
Pressing [OK] saves the required mode and returns to the previous screen.
Pressing [POWER] to ON will display the screen as seen to the right.
Pressing [OK] from the DDS screen enters the MAIN MENU.
VAPURE VP-Series Salt Chlorinator.
When pressed the Mode will change AUTO to OFF then ON.
Pressing [POWER] to OFF will display the screen as seen to the right
Pressing [+] takes you to the last menu and using the [-] or [OK
.
Pressing [+] 5 times above displays the display shown to the right.
Pressing [+] takes you to last menus.
[-] allows you to adjust the POWER/MODE setting from AUTO to OFF to ON.
6.3 CHLOR BOOST
to operate for 8hrs and automatically sets the chlorine setting to 100%.
Super-Chlorinate. The bottom line will alternate between "[CHLOR BOOST] to END"
This allows for an injection of extra sanitising time, also know as Chlorine Boost or
and the fault message if there is any fault during CHLOR BOOST.
T
wo digits 08 wn to the right.
Pressing [+] or [-] increases or decreases in increments of 01:00 hrs whilst running.
When completed the unit will return to the DDS screen in the last selected POWER/MODE state
and the CHLOR BOOST LED goes OFF.
Pressing [ BOOST ] again allows you to exit the CHLOR BOOST screen and return to the DDS screen.
CHLOR BOOST can also be entered by pressing the [OK] button in MAIN MENU and scrolling to
CHLOR BOOST.
BEFORE ENTERING CHLOR BOOST YOU MUST BE IN THE DDS SCREEN.
[ BOOST ] button sets your VAPURE VP-Series Salt Chlorinator and pump
When in operation the LED will be on. After the set time it reverts back to last selected
POWER/MODE unless ON then it reverts to AUTO.
The unit automatically defaults to 08:00 hours of ON time and the timer starts counting down
immediately.
www.crystalas.com
65a010a5-6d71e2d3-6b3148b4-770d42ea65a010a5-6d71e2d3-6b3148b4-770d42ea65a010a5-6d71e2d3-6b3148b4-770d42ea